At the present time, we have experience in investigating the causes of emergency shutdowns and we can give any expert conclusion about of any reasons of emergency shutdowns or failures of expensive equipment, including but not limited to the following list of manufacturers:
1. ENERPROJECT SA (Switzerland).
2. GEA Grasso GMBH (Germany).
3. LLC “VMZ” – LLC “Firma NOEMI” (Russia).
4. HAFI ENGINEERING & CONSULTING GMBH (Austria).
5. ELTACON ENGINEERING B.V. (Netherlands).
6. TOROMONT (Canada).
7. CAMERON (USA).
8. GEA TECHNOFRIGO Spa (Italy).
For the sending of requests for this service, please use the following email address: info@extrade.ru.com
Parts of the gas filter got into the oil system and oil was carried away from the unit. The reason for the destruction of the filter: low quality of manufacturing.
The clogging of the impulse piping of the oil supply to the compressor caused the compressor to fail. The reason for clogging: low quality of filter elements.
As a result of the absence of a drain collector on a mobile compressor, the condensate got into the equipment under pressure test which resulted in contamination of the internal volume of the equipment. The reason for the formation of condensate: low-quality maintenance of mobile compressor.
Due to the incorrect selection of the crane sling that do not correspond to the carrying weight, the sling were broken after lifting the equpment, were damage of the equpment. Reason: wrong capacity of the weight of sling.
As a result of low grounding chain contact, an increase in motor current has occurred. Reason for low grounding chain contact: poor assembly.
As a result of the cracking of the pressure vessel, all oil was released from the compressor unit. The reason for the cracks: non-compliance with the technology of the welding process.
As a result of paraffin contamination of the tubes in the heat exchanger, a decrease in heat conductivity occurred. The reason for the formation of paraffin: low-quality of gas preparation.
As a result of the deep corrosion of the high-voltage motor’s ex-proof ring, an emergency shutdown of the motor and, shutdown of all plant of course.
As a result of the use of an analogue oil filter with low quality, there was a destruction of the filtering part occurred. The reason of the destruction: low quality materials of the filter element.
As a result of the installation of a temperature sensor with a shorter sensitive part on the one of the three units, the signal of temperature was different, which resulted in differences in the temperature set-point list. Reason for installation: wrong the assembly process technology.
As a result of the hole in the cover of the mechanical seal, oil was released from the compressor. The reason for the formation of the hole: bad control the process of input control and the process of pressure testing equipment.
